![]() Pet Turbo Tool may be used for upholstered furniture, draperies, and carpeted stairs.ĭ. Crevice Tool may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards.Ĭ. Extension Wand is used to give extra length to your hose. To avoid damage to carpet, rugs, furniture and flooring, avoid tipping cleaner or setting it on furniture, fringed area rugs, or carpeted stairs during tool use. The vacuum is ready for tool use when handle is in upright position.īrushroll continues to turn while product is turned on and handle is in upright position. Tools allow for cleaning surfaces above the floor and for reach- ing hard to clean areas. If the vacuum is difficult to push, push down and turn knob to the next higher setting. For high pile carpet, use high carpet setting to ease pushing effort.Low through High settings: Adjust depending on carpet type.Hard floor setting: for use on hard floors only.(Do not pull the cord past the red tape.) CARPET HEIGHT ADJUSTMENT*Ģ.4 To adjust height setting, PUSH DOWN and TURN knob (C) to desired height setting.įor maximum cleaning performance, the following carpet height settings are recommended: When red tape is visible on the cord, the cord has reached its full length. When pulling on the cord, yellow tape will identify when the cord is almost fully extended. NOTE: Pull the cord all the way out prior to using to prevent the cord from overheating. CORD RELEASEĢ.3 Prior to using, grasp the end of the plug and pull to release the cord from the cord reel until red tape is reached. To turn vacuum OFF (O=OFF), push switch to OFF position. ![]() To turn vacuum ON (I=0N), push ON/OFF switch (A) to ON position. Dirt Cup is secure when you hear a click.Ģ.2 Plug cord into electrical outlet. Insert the hose into hose tube until you hear a click.ġ.4 Place Crevice Tool into Extension Wand and slide into tool storage area on left back side (C) of vacuum and place Pet Turbo Tool on right back side (E) of vacuum as shown.ġ.5 Place Dusting Brush (F) on top of Extension Wand.ġ.6 Place bottom of Dirt Cup into vacuum body first. Using a Phillips screwdriver, fasten (1) large screw behind handle into Vacuum Base.ġ.3 Wrap hose around top of hose guide located on the handle. ATTACH HANDLEġ.2 Insert handle section into Vacuum Base. Make sure all parts are located before disposing of packing materials. Remove all parts from carton and identify each item shown.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |